Checkline TT02 User Manual

Page 22

Series TT02 Digital Torque Tool Testers

User’s Guide

10. After all the clockwise calibration points have been completed, the display will appear as follows:

Press ENTER.

11. At the completion of the counter-clockwise calibration, the display will appear as follows:

To save the calibration information, select “SAVE & EXIT”. To exit without saving the data select
“EXIT W/O SAVING”.

12. Any errors are reported by the following screens:

Displayed at the start of calibration if a disallowed unit is selected.

Ensure that the load is not swinging, oscillating, or vibrating in any manner. Then try again.

The calibration load does not match the set value.

LOAD NOT STABLE

PLEASE TRY AGAIN

CALIBRATION

Units must be kgFmm.

PLEASE TRY AGAIN

PRESS ENTER

CALIBRATION

CLOCKWISE

LOAD TOO LOW

PLEASE TRY AGAIN

CALIBRATION

COMPLETE

SAVE & EXIT

EXIT W/O SAVING

CALIBRATION

CLOCKWISE COMPLETE

REVERSE DIRECTION

FOR CCW

Attach necessary
weight fixtures.

THEN PRESS ENTER