Checkline TT02 - Manual (Page 15)

Series TT02 Digital Torque Tool Testers User’s Guide
14
10.5 DATA Key Settings
To configure the functions of the DATA key, select DATA Key from the menu. The display will appear as
follows:
RS232/USB Output
Outputs data via the serial and USB ports
Mitutoyo Output Outputs data via Mitutoyo (Digimatic) through the serial port
Memory Storage Stores a reading to memory (refer to the Memory section for details)
Any combination of the above functions may be selected.
10.6 I/O Connector Pin Diagram (female)
Pin No. Description Input / Output
1 Signal Ground ---
2 Counter-clockwise Overload Output
3 RS-232 Receive Input
4 RS-232 Transmit Output
5 +12V DC Output
6 Analog Output Output
7 Clockwise Overload Output
8 Mitutoyo Clock
Output Bit 2
Output
9 Mitutoyo Data
Output Bit 0
Output
10 Mitutoyo Request
Input Bit 3
Input
11 * Set Point Pin 1 (active) * Output
12 * Set Point Pin 2 (active) * Output
13 * Set Point Pin 3 (inactive) * Output
14 Do not connect ---
15 Mitutoyo Ready
Output Bit 1
Output
* Note: The output assignments for pins 11 and 12 depend on several factors. Refer to the table below
for details:
DATA KEY
* RS232/USB Output
Mitutoyo Output
Memory Storage