Checkline WTTM-GEN1 User Manual
Page 4
– 4 –
3.0
S
ETUP
Place the WTTM Wire Terminal Tester on a level and stable work area where the user
can perform the testing in a comfortable manner. The surface should be clean and
grease-free, so that the instrument does not slip.
Make sure that there is no residue from the
pack-aging materials stuck under and around
any of the operating components especially in the
recessed area around the rotating terminal fixture
(see photo). Use of compressed air to clear any
debris from these areas is recommended.
Please note that the instrument weighs approximately 42 pounds (19 kg), so take care
when lifting and moving. We suggest that the instrument be located in close proximity
to an AC-Power outlet.
4.0 AC-O
PERATION
The WTTM must be operated using the AC-Adapter.
– 17 –
11.0 S
PECIFICATIONS
Measuring Range*
0–50 Kg / 0–110 lbs / 0–500N or
0–100 Kg (0–220 lbs / 0–1000N)
(units selected via keypad)
Resolution
0.01Kg / 0.1 lbs / 0.1 N
Terminal adapter
slot width (mm)
0.5, 0.8, 1.0, 1.4, 1.5, 2.0, 2.5, 3.0, 3.5, 4.0, 5.0, 6.0
Accuracy
±0.5% F.S. or better
Operating Mode
Continuous
Displays actual value in Kg, lbs. or N
Peak-Hold
Displays peak value in Kg, lbs. or N
Wire Diameter
SAE AS7928 II
AWG 8. . .30
IEC 60352-2
Cross section 0.05. . .10mm2
Maximum
0.236" (6mm)
Overload
120%
Display
LCD, 4–1/2 digit, 12mm high
Update Time (msec)
Standard
1000, 500, 333, 200, 100, 50 (selectable)
Peak
1
Memory
Peak Value
Power Supply
AC adapter (100-240V/50-60 Hz)
Interface (RS232C) Baud rate: 2.4, 4.8, 9.6, 19.2 Kb (selectable)
Temp. Range
Operating 32
to104
°F
(0 to 40 °C)
Storage
–4 to 140 °F (–20 to 60 °C)
Weight, approx.
42lbs. (19 Kg)
Dimensions
14.2" x 6.3" x 3.33" (360 x 160 x 110 mm)
Protection Code
IP40
Material
Anodized aluminum, steel and stainless steel
* Low-range model available on special order basis.