Checkline FGS-100PX - Manual (Page 15)

15
Clearing the previously stored program helps
in eliminating program confl icts.
Clearing the previously stored program helps in eliminating program confl icts. To reset the program
memory, press and hold “RST/^” and then press “SET”. The display will read “CCCC”.
NOTE: An RS232C output is produced when using this mode of operation. See 6.0 RS232C Output
below for details.
Data will be outputted when stand platform reaches a manual limit switch or a programmed
force limit.
To Run Program:
Run the program by selecting “PROG START” on the display panel.
6.0 RS232C Output Format (using FGV-X Force Gauges)
“Cr” means carriage return
SING/CONT Mode
Plus Peak
Direction A: PULL
B: PULL
Minus Peak Distance
NOTE: Direction A: PULL, B: PUSH
“Cr” means carriage return or Enter