Brookfield DV-I Viscometer User Manual
Brookfield Measuring instruments
Table of contents
Document Outline
- TABLE OF CONTENTS
- I. INTRODUCTION
- I.1 Components
- I.2 Utilities
- I.3 Specifications
- I.4 Set-Up
- I.5 Safety Symbols and Precautions
- I.6 Key Functions
- I.7 Cleaning
- II. GETTING STARTED
- II.1 Auto Zero
- II.2 Spindle Selection
- II.3 Speed Selection & Setting
- II.4 Autorange
- II.5 CGS or SI Units Selection
- II.6 Temperature Display in °F or °C Selection
- II.7 Out of Range
- II.8 Operation
- II.9 Timed Modes for Viscosity Measurement (available in instruments with V3.0 or greater)
- Appendix A - Cone/Plate Viscometer Set-Up
- Appendix B - Viscosity Ranges
- Appendix C - Variables in Viscosity Measurement
- Appendix D - Spindle and Model Codes
- Appendix E - Calibration Procedures
- Appendix F - Special Speed Sets
- Appendix G - Communications
- Appendix H - Laboratory Stand with Parts Identification
- Appendix I - DVE-50 Probe Clip
- Appendix J - Fault Diagnosis and Troubleshooting
- Appendix K - Warranty Repair and Service
- Appendix L - Viscosity Test Report