Brookfield CAP1000 Viscometer - Manual (Page 8)

Brookfield Engineering Labs., Inc. Page 6 Manual No. M02-32A0607
3) Verify that the viscometer’s power requirements match your power source BEFORE con-
necting it to power.
The AC input voltage and frequency must be within the appropriate range as shown on
the back of the viscometer head .
Note: The CAP Viscometer must be earth grounded. Use the three (3) wire power cord! Do
not alter!
4) Connect the power cord to the viscometer and to the power supply (source).
5) If using a printer, connect the printer cable to the printer port and printer.
Note: Ensure that both the printer and the CAP 1000+ are off when connecting cables.
I. safety symbols and Precautions
Safety Symbols
The following explains safety symbols which may be found in this operating manual.
Indicates hazardous voltages may be present.
Caution: HOT surface.
Refer to the manual for specific warning or caution information to avoid personal injury
or damage to the instrument.
Safety Overview
If this instrument is used in a manner not specified by the manufacturer, the protection
provided by the instrument may be impaired.
This instrument is not intended for use in a potentially hazardous environment.
In case of emergency, turn off the instrument and then disconnect the electrical cord
from the wall outlet.