Building a quickstack – 360 Systems DigiCart/EX User Manual

Page 58

• 29BPlayback

Building a Quickstack

• Press the

PAUSE [BUILD LIST]

button. (It will illuminate when pressed.)

• Select a cut or Playlist (an event) to be added to the Quickstack.
• Press the

PLAY

button to add the first event to the Quickstack. The number displayed under

the event ID counts the entries in the Quickstack. The PLAY button will begin to blink,
indicating that item has been entered into the Play queue. The time under the name shows
total Quickstack duration.

• Repeat the above steps to add as many events the list as are needed.

If you wish to check the Quickstack's contents:

• Press the VIEW

LIST

button.

• Use the

selection knob

to scan through the Quickstack.

(NOTE: Because the viewable list represents events in the queue, the currently playing
event will not read out as cut #1, only the events that follow will be listed. Once the
list is saved, the current event will be #1 and all others will read in order.)

• Release PAUSE (or press the MAKE PLAYLIST button on an RC-320 remote) to play the

Quickstack. The top line of the command display shows the last item in the Playlist, the
bottom line presents the current item and its timing information.

While playing, use the

VIEW LIST

button and

selection knob

to see the remaining items in the

list. The number at the upper left shows how many items the selected event is away from the
Cut that is currently playing.
Pause and Loop may be used while Playlists are running. At any time during playout of a
Quickstack, you may press the

LOOP

button. The current selection will repeat until Loop is

disengaged. Refer to button operational descriptions in Chapter 2, Control Panel.