Panasonic NV-H65 Series - Manual (Page 9)

® ® o ® ® ©
COLOUR/TEST SIGNAL
COLOUR '
AUTO-
jT]
-TEST
i|5l Turn the TV set on and select the AV programme
position or another programme position that is not
occupied by any TV station.
^ Press the VTR On/Off Switch to turn the VTR On.
(FRONT SIDE)
^
VTR
•The corresponding indicator lights up.
10 Press the VTR/TV Selector to “VTR" position.
The NV-H65BA is not equipped with this selector.
-------------------------------------------------------------------------
VTR/TV
©VTR Indicator will appear in the Multi-Function
Display.
ill Set the Colour Mode/Test Signal Switch to “TEST”.
(REAR SIDE)
COLOUR/TEST SIGNAL
COLOUR i
AUTO-
m
- TEST
RF Converter Channel Selector. (NV-H65A, EA)
This switch is used to select the RF channel which is not
occupied with any TV station, {NV-H65A: 0 or 1;
NV-H65EA: 2 or 3.)
-RF Signal Level Switch;
Used to attenuate the reception of the VHF and/or UHF
aerial signals. If the reception is normal, set to “HIGH”. If
the signal is strong (stripes appear in the upper part of the
picture), set to “LOW”.
Tune the selected programme position (channel) of the
TV set to the VHF or UHF channel shown below for
your model. Confirm on the TV set that the received
test pattern is as shown below.
NV-H65A VHF channel 0 or 1* *
NV-H65EA VHF channel 2 or 3
NV-H65BA UHF channel 36
iSi;
.V'<; !
V'l
NV-H65A only
*ln some areas chan­
nel 0 may be used by
local TV station. In
this case switch to
channel 1.
Set the Colour Mode/Test Signal Switch to “AUTO”.
Your TV is now ready to receive the RF output signal
from the VTR.
—
COLOUR/TEST SIGNAL
COLOUR
AUTO
m
TEST
©If, during recording or playback, the colour is not
satisfactory, it can be stabilized by setting Colour
Mode/Test Signal Switch to COLOUR.