Panasonic PV-D4752 - Manual (Page 28)

Multi-Brand control Feature
Multi-Brand Control Setup
The Remote Control can be set to control some TV and
Cable Box/DSS functions.
Find your TV and Cable Box/DSS Receiver
Brand Code Number on the following page.
1
Setup for TV control,
hold down TV button,
enter code with NUMBER keys.
Setup for Cable or DSS control,
hold down DSS/CABLE button,
enter code with NUMBER keys.
• If code number is 100 or greater,
->► e.g., press 1 - 0 - 2 for 102.
Confirm code entry,
->► press POWER to turn selected unit on or off.
• See table below for controllable functions in each mode.
' Repeat setup after remote battery replacement.
' Remote will not control every TV, Cable Box, or
DSS made by the manufacturer listed. If you get
no response, your particular unit cannot be
controlled. There are NO additional codes for the
products listed. If your product is not listed, then
the remote is not compatible with that product.
Using Muiti-Brand Controi
After remote is set up, you can select VCR, DVD, TV, or
DSS/CABLE for the desired function.
Press VCR,
DVD,
TV, or DSS/CABLE
on the remote.
(Table below shows available remote buttons for each mode.)
Unit
Mode^^v^^
DVD/VCR TV CABLE/ DSS
DVDA/CR All
VOL +/-
TV EJEC7/OPEN/CLOSE*,
DISPLAY, PLAY, STOP,
FF/SLOW+, REW/SLOW-,
VCR/TV, PAUSE/Sr/LL, SKIP,
AUDIO, CM/ZERO,
TAPE POSITION,
COUNTER RESET , SPEED,
REC
POWER, INPUT,
NUMBER keys,
ENTER,
CH A/T,
VOL +/-
VOL +/-
POWER, ENTER,
NUMBER keys
(except lOOkey),
CH A/T
CABLE/
DSS
Bold: VCR Function
Italic: DVD Function
Not all functions listed may be controllable.
In TV or DSS/CABLE mode, it may be necessary to press ENTER after pressing
NUMBER keys for channel selection.
POWER
VCR
DSS/
CABLE
-TV
DVD
NUMBER
keys
■ ENTER
Bold Italic: VCR and DVD Functions
Normal: TV, Cable Box or DSS Receiver
28
For assistance, please call: 1-800-211-PANA(7262) or send e-mail to: [email protected]