G-code programming, Preparations, Operations – Panasonic NV-HD630 User Manual

Page 32: On screen dispiay and dispiay symbol, Press g-code, Enter a g-code number, Press enter, Press timer rec, Ia a a, S @ s i

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

G-Code Programming

Programming is now easier than ever; simply enter the G-

Code number found in the programme scheduling pages of
newspapers and magazines.
G-Code numbers are numbers assigned to programmes
listed in the TV programme schedule found in newspapers
and TV guides. When these numbers are entered, the
numbers are converted to actual programming.

Preparations

• Insert a video cassette tape with an intact erasure

prevention tab.

• Confirm that the TV is on and the VCR viewing channel is

selected.

• Turn on the VCR.
• Check that the clock is set to the correct time. If it has not

been set, refer to page 18.

Set VCR—TV switch to VCR for using the
numeric buttons and the G-CODE button.

Operations

On Screen Dispiay
and Dispiay Symbol

Press G-CODE.

• Ensure that VCR—TV switch

is set to VCR.

G - C O D E

Enter a G-Code number.

Example:123456

»It is also possible to check

the number with VCR display
without appearing the On

Screen Display.

»If you have entered the wrong number, press

CANCEL then enter the proper number. An
alternative method is to press < and then enter the
proper number.

i ? 3 H 5 b - - -

Press ENTER.

•The entered programme

appears on the display.

•The starting time and the

ending time appears
alternately each 5 seconds
on the VCR display.

3D n i D u i :

L J I !

1 J I 3

»Confirm that the number

corresponds to the right
programme. If the display

looks like this and □ on the

VCR display flashes on and
off: select the programme
position of your VCR which

receives the TV station you

entered at step 2 using the

(CH) then press ENTER.

CH DATE ON OFF

23 17M0 13:4$ 14:15 SF

S @ S i

OFF SP

3 3

lu- tc

L J

I I

M i l

CH DATE ON OFF

— 17M0 13:45 14:15 SP

-:|ia a a

•To make any corrections, use buttons 0 (DATE), O

(ON) and O (OFF) the same way as described on
page 29.

Press TIMER REC □.

TIMER REC

Notes:
• To select the desired tape speed, press SPEED after step

• When the G-Code number is used for programming, the

recording time may be slightly longer than the actual
programme time.

• Repeat steps 2 and 3 if “PROGRAMME IS

INCOMPLETE.” appears.

• When programming two or more programmes, repeat

steps 1-4.

• The procedures for checking and cancelling a timer

programme are the same as on page 31.