To change the rf output channel – Panasonic NV-HD630 User Manual

Page 11

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

To Change the RF output Channel

In some rare cases after tuning the TV to your VCR,

interference may be visible on the picture. To get rid of this
interference, you can manually adjust the RF output channel
a few channels up and down from the current setting. The
procedure is described below.

Operations
1 Hold down MENU for 5 seconds or more.

• The VCR display changes as shown below and the

VCR picture on the TV displays this pattern.

Example for
NV-HD630A

Example for
NV-HD630EA

2 Enter the desired channel number (AU28-69, NZ21-69) by

using the numeric buttons or the >✓ and /\ buttons.

> Ensure that VCR—TV switch is set to VCR.
> Set the RF output channel of the VCR to “—” (RF

OFF) when the VCR is connected to the TV via the
AUDIO VIDEO cable.

Press the >✓ and /s. buttons to display “—”.

For NV-HD630A

-♦28«- -»69«-

For NV-HD630EA

—»21«- -*69«-

(RF OFF)

Example:

3 Press MENU to finish the setting mode.

4 Retune your TV to the new RF channel for the VCR.

Note:
Even if the RF output channel has been changed, it is not
necessary to perform Auto Tuning.