Panasonic NV-HD630 - Manual (Page 16)

Setting the Remote Controller for
Operation of your TV
You can operate the TVs of the manufacturers listed below
with the remote controller after setting it.
Set VCR—TV switch to TV for using POWER (b, the
V and /s buttons and the numeric buttons.
^ ' f’“'j
* *Y
ii№
01 Panasonic/National
02 Panasonic/National
03 Panasonic/National
04 Panasonic/National
05 SONY
06 TOSHIBA
07 JVC
08 HITACHI
09 MITSUBISHI
10 MITSUBISHI
11 SHARP
12 PHILIPS, SAMSUNG
13 NEC
14 SANYO
15 GOLDSTAR
16 GOLDSTAR
17 SAMSUNG
18 SAMSUNG
19 SANYO
This setting procedure allows you to operate the TVs of
some manufacturers using the supplied remote controller.
Preparation
Set the VCR—TV switch to TV.
Operations
1
Find the manufacturer number of your
TV while referring to the folllowing
table.
While holding down POWER (!), use
the numeric buttons to enter the
manufacturer number. This completes
the settings for the TV manufacturer.
• Be sure to enter the number in two digits.
Example; 1-^01
To confirm that the correct settings
were made, check whether the TV can
be operated properly.
• When a manufacturer has multiple numbers in
the following table, try entering other numbers if
the TV operations cannot be performed properly,
and then select the optimal number.
Notes:
• If you are using a Panasonic TV, this setting has already
been made, and so you do not need to perform the above
setting procedure. However, this remote controller may
not work with some Panasonic TVs.
• Some TV models cannot be operated using this remote
controller (including all TVs non-remote compatible).
16