Panasonic DVCPRO AJ-D220 P - Manual (Page 6)

Controls and Their Functions
Front Panel
O POWER switch
When the ON side is pressed, the power is turned
on, and the counter display area lights.
0 Cassette slot
A news gathering cassette, general-purpose
cassette or consumer-use cassette with an adaptor
is loaded through this slot.
O EJECT button
When this is pressed, the tape is unloaded, and
several seconds later the cassette is automatically
ejected.
When the counter display area shows the CTL
display, the display is now reset.
o
remote lamp
This lights when the LOCALVMENU/REMOTE
switch has been set to the REMOTE position.
0 WIDE lamp
This lights in the 16:9 wide screen mode.
0“Consumer-use cassette loaded” display lamp
This lights when a cassette recorded on a
consumer-use DV unit has been loaded.
OREPEAT lamp
This lights during repeat playback.
QSERVO lamp
This lights when the drum servo and capstan servo
are locked.
©Channel condition lamps
One of these lamps lights {green blue -»■ red) in
accordance with the status of the error rates.
Green: This lights when the error rates for the video
and audio playback signals are both
satisfactory.
Blue: This lights when the error rate for either the
video or audio playback signals has
deteriorated. The playback picture is still
normal even while this lamp is lighted.
Red: This lights when either the video or audio
playback signals are corrected or
interpolated.
Level meter
This displays the audio signal levels.
During playback, it displays the audio output signal
levels.
This lights when a cassette has been loaded into
the unit.
©Counter display area
The TC and CTL counts, on-screen information and
messages appear in this area.
©LOCAUMENU/REMOTE switch
This is operated when menu settings are to be
performed or when the unit is to be controlled from
a remote location.
LOCAL: For controlling the unit using the controls
on the unit’s operation panel.
MENU: For setting the on-screen menu.
REMOTE: For controlling the unit using the remote
controller.
©BEGIN button
This sets the repeat playback start point, and it
displays the currently entered start point.
©END button
This sets the repeat playback end point, and it
displays the currently entered end point.
©CH3/CH4 lamp
This lights during DV format playback when the
audio signals have been set in CH3 and CH4.
©AUDIO OUT SELECT button
This selects the audio signals which are to be
output.
©Headphone jack
When stereo headphones are connected here, the
playback sound can be monitored through the
headphones.
©Volume control
This is for adjusting the headphones volume.
©Remote control sensor window
©REW button
When this is pressed, the tape is rewound, and
when ‘TAPE" is set for the “S/F/R BACK SEL" set­
up menu item, the playback picture can be
monitored.
©STOP button
When this is pressed, the tape stops traveling, and
when “TAPE" is set for the “S/F/R BACK SEL” set­
up menu item, the still picture can be monitored.
Even in the stop mode, the drum continues to rotate
with the tape kept in close contact with the drum.
After the unit has been kept in the stop mode for a
specific period of time, it is automatically set to the
standby off mode in order to protect the tape. It is
set to the stop mode immediately after a cassette
has been loaded into the unit.
©FF button
When this is pressed, the tape is fast forwarded,
and when ‘TAPE’’ is set for the “S/F/R BACK SEL”
set-up menu item, the playback picture can be
monitored.
-
6
-