Panasonic DVCPRO AJ-D220 P - Manual (Page 21)

Set-up Menus
MEMORY MODE menu
Item Setting
Description of settings
No.
Superimposed
display
No.
Superimposed
display
300 MEMORY 0000 OFF This sets the memory operation.
MODE 0001
0002 MEM STOP
REPEAT 1
0: No memory operation.
1: The tape stops near the BEGIN point when it is fast
0003 CONTINUE forwarded or rewound.
2: When the tape reaches the end, it is rewound to the
BEGIN point where it stops.
3; When the tape reaches the end, it is rewound to the
BEGIN point where it is played, and this process is
repeated.
301 BGN/END PRESET This sets the BEGIN point and END point.
The underlined number and item are the factory settings.
TAPE PROTECT menu
Item Setting
Description of settings
No.
Superimposed
display
No.
Superimposed
display
400 STILL TIMER 0000 0.5S This selects the time taken until the unit is set to the
0001 5S tape protection mode when it has been left standing in
0002 10S the stop, play pause or still mode.
0003 30S (Units: S = seconds, MIN = minutes)
0004 1MIN
0005 2MIN
401 SRC PROTECT 0000 STEP This sets the tape protection operation which is
0001 HALF performed when the unit has been left standing in the
pause mode.
0: Step (step FWD in the pause mode)
1: Half loading (standby OFF)
The underlined number and item are the factory settings.
• When using a consumer DV cassette tape, tape protection mode is set after 10 seconds, even
if STILL TIMER is set to "SOS”, “1 MIN” or “2MIN”.
• When the unit is left in stop mode, the tape protection operation is always half loading
(standby OFF).
-21
-