Crestron electronic Ethernet - Manual (Page 8)

Ethernet OEM Module Crestron eServer™
COM IN
This 9-pin connector (DB9F) is used as a pass-through for device control. This
bidirectional serial port is used for RS-232 communication. It can also be used for
configuring the device with IP address, mask, etc.
NOTE: This port is also known as the Console (Main) port in some setup menus
discussed in "port" on page 15.
NOTE: The pinout of each 9-pin port is non-standard (refer to table after this note).
This may result in a conflict with some equipment and therefore do not use all nine
pins. Only the required pins for each communication type should be connected.
eServer Pinout (COM IN)
PIN DIRECTION DESCRIPTION
1 To eServer Carrier Detect (CD)
2 From eServer (TXD) RS-232 Transmit Data
3 To eServer (RXD) RS-232 Receive Data
4 From eServer DTR
5 RS-232 Signal Common
6 - No Connect
7 To eServer (CTS) RS-232 Clear to Send
8 From eServer (RTS) RS-232 Request to Send
9 - No Connect
ETHERNET
This RJ45 modular connector provides Ethernet connection, thereby making the unit
IP addressable and compatible with 10 BaseT Ethernet systems. The Ethernet port is
the standard 10 BaseT pinout. Refer to the pinout table after this paragraph.
Ethernet Port (RJ45) Pinouts
PIN DESCRIPTION
1 TD+
2 TD-
3 RD+
4 No Connect
5 No Connect
6 RD-
7 No Connect
8 No Connect
4 • Ethernet OEM Module: eServer™ Operations Guide - DOC. 8148