Before requesting service, Before requesting service 1 – Panasonic NV-FS1 User Manual

Page 35

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

BEFORE REQUESTING SERVICE

Before requesting service, check the following points once

again.

SYMPTOM

CAUSE

REMEDY

Power doesn’t turn on.

Mains lead is not connected.

Connect mains lead to mains outlet.

The Timer Record Function is set to “On”.

Set the Timer Record Function to “Off”.

Power is on but unit doesn’t

operate.

Dew condensation inside the VTR.

Wait until the Dew Indicator “ d ” goes off.

Safety devices are operating.

Turn off the VTR On/Off Switch, disconnect
mains cord from outlet, then reconnect mains
cord to mains outlet and turn on the VTR

On/Off Switch again.

TV programmes cannot be

recorded.

Connection of aerial lead is not correct.

Connect aerial lead correctly.

Reception channel is not properly tuned.

Tune reception channel.

The Input Signal Selector is not set correctly. Set the Input Signal Selector to "Tuner”.

OTR Function (One-Touch Timer

Recording) cannot be performed.

Clock is flashing “0:00”.

Set clock to present time.

Unattended timer recording

cannot be performed.

Recording start or recording stop time setting

is incorrect.

Set recording start and recording stop time
correctly.

The Timer Record Function is set to "Off”.

Set the Timer Record Function to “On”.

Clock shows incorrect time.

Adjust clock to present time.

Clock is flashing at “0:00”.

Set clock time and date, and perform timer
setting.

The Input Signal Selector is not set to

“Tuner”.

Set the Input Signal Selector to “Tuner”.

If you attempt to carry out
Recording, Timer Recording, or
OTR, the cassette will be
automatically ejected.

Accidental erasure prevention tab on the
cassette is broken out.

Cover tab hole with adhesive tape.

Recording via external input

terminals cannot be performed.

The Input Signal Selector is not set correctly. Set the Input Signal Selector to “Line/Audio”.

Recorded programmes with two-

channel sound (stereo, bilingual
or Simulcast) can not be played

back.

Setting of the Audio Playback Mode Selector
Button is not correct.

Press the Audio Playback Mode Selector
Button to select the desired audio playback
mode. (See page 21)

Hi-Fi tracking is misaligned.

Precisely align the tracking of the hi-fi sound

track.