Panasonic NV-FS1 - Manual (Page 31)

CAMERA RECORDING
O Turn the Camera AC Adaptor on and make the
necessary adjustments on the camera.
Refer to the operating instructions of the camera you
are using.
0 Press the Record Button (•) on the VTR to start
recording.
Avoid recording unwanted material:
Press the Pause/Still Button (H) of the VTR, and the
recording will stop temporarily. To restart recording, press
the Pause/Still Button
(II), again.
O Press the Stop Button (■) on the VTR to stop the
recording.
•For playback of a tape that was recorded via a
camera, select the audio track on which the sound
from the camera microphone was recorded by
pressing the corresponding Audio Playback mode
Selector Button.
•If you leave the VTR in the pause mode for more
than 5 minutes, the VTR will stop automatically to
protect the tape and the video heads.
•Even if the video camera is equipped with video
recorder remote control functions, this VTR can not
be remote-controlled from the camera.
Preparation
•Connect the Video Camera via the Camera AC Adaptor to
the VTR as shown in the illustration above.
•Set the Input Signal Selector to "Line/Audio”.
•Insert a video cassette with the erasure prevention tab
intact.
When a video cassette is already inside the VTR, press
the VTR On/Off Switch to turn it on.
•Set the Audio Rec Level Control Selector to “AGC".
•Set the Tape Speed Selector to “SP” or “LP”.