To change the rf output channel, Operations – Panasonic NV-HD675 User Manual

Page 11

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

To Change the RF output Channel

In some rare cases after tuning the TV to your VCR,

interference may be visible on the picture. To get rid of this
interference, you can manuaily adjust the RF output channel
a few channels up and down from the current setting. The
procedure is described below.

Operations

1 Hold down MENU for 5 seconds or more.

• The VCR display changes as shown below and the

VCR picture on the TV displays this pattern.

Set VCR—TV switch to VCR for
using the numeric buttons or

Example for
NV-HD675A

Example for

NV-HD675EA

PvuiteMfi VCR

2 Enter the desired channel number (AU28-69, NZ21 -69) by

using the numeric buttons or the v and /\ buttons.

• Ensure that VCR—TV switch is set to VCR.
• Set the RF output channel of the VCR to “—” {RF

OFF) when the VCR is connected to the TV via the
AUDIO VIDEO cable.

Press the v and

buttons to display “—

For NV-HD675A

_^28<-------- >69<-

] [

For NV-HD675EA

—» 21 •••—♦ 69^

(RFOFF)

Example:

28; © —©-^®

3 Press MENU to finish the setting mode.

4 Retune your TV to the new RF channel for the VCR.

Note:
Even if the RF output channel has been changed, it is not
necessary to perform Auto Tuning.