Panasonic Panafax UF-127M - Manual (Page 51)

RECEIVING DOCUMENTS
RECEPTION MODES
When your machine receives documents, you can select one of three modes o f Reception as shown
below.
Your machine is preset to the Fax Mode. You can select another mode of Reception by pressing
the 1FAX/TELEPHONEI key.
Telephone Mode (TEL)
When your machine is set to this mode, your machine is ready for voice communication only.
You must manually press [ START
I and then hang up the handset to receive document.
Fax Mode (FAX)
When your machine is set to this mode, your machine will begin to receive documents automatically
after it rings 2 times.
AUTO Mode (AUTOMATIC)
This mode is useful when you want to use the telephone line for both Fax and Voice communication
(for example when there is only one telephone line in your office).
Either of the following two modes can be selected by changing the TAM parameter shown in the
Fax Parameter Table (see pages 24 - 25).
(1) TEL/FAX Reception
This mode is selected by setting the TAM Parameter to “None” (Not connected) and your machine
then automatically switches to document reception or voice communication by monitoring the
line for a fax signal.
(2) TAM/FAX Reception
You should select this mode when you connect a TAM (Telephone Answering Machine)
to the facsimile.
This mode is'selected by setting the TAM Parameter to “Connected”. The function of this mode
is described in Appendix I (see page 68).
NOTC
1. Depending on the PBX conditions at the moment the fax machine is called, the number of rings can differ from
the setting number.
2. Depending on the model of Telephone Answering Machine (TAM) that is connected. The TAM/FAX Reception mode
may not work satisfactory.
46