Panasonic Panafax UF-127M - Manual (Page 28)

Fax Parameter Table
Parameter
Number
Parameter
Setting
Number
Setting Comments
01 Resolution
1* Standard
Setting home position of the
Resolution mode.
2 Fine
3 Super Fine
02 Original (Contrast)
r Normal Setting home position of the
Original contrast mode.
2 Light
03 Stamp
1 Off Setting home position of the
Stamp function Off/On.
2* On
05 Journal Print
1 Off
Selecting whether or not the
machine prints the journal
automatically after every 32
transactions.
2* Automatic Print
06 Header Print
1 * inside
Selecting printing position of the
header.
Inside; inside document the area.
Outside: outside the document area.
None: header is not printed.
2 Outside
3 None
07 Dialing Method
1 Tone
Selecting whether the machine
dials by Tone or Pulse (rotary)
method. 2* Pulse
13
XMT in no paper
(See note 1)
1* Allowed
Selecting whether or not the
machine is allowed to transmit
document when no recording
paper is installed.
2 Not Allowed
15
ECM (Error
Correction Mode)
1 Off Selecting whether or not the
machine performs ECM function
if the line is poor.
2* On
17 Substitute Reception
1 invalid Selecting whether or not the
machine receives to memo-ry
when recording paper runs out. 2' Valid
18
Stamp at
MEM.XMT
1 • Off
Selecting whether or not the
machine stamps the original
document when storing into
memory.
2 On
19 XMT Journal
1 * Off
Selecting whether or not the
machine prints a transmission
journal automatically after each
transmission.
2 Automatic Print
32 Initial Operator Call
1 Off
Selecting whether or not the
machine sounds operator call
when no fax signal is received in •
the fax mode.
2* On
37 TAM
1 * None
Selecting whether or not a tele­
phone answering device is
connected to the unit.
2 Connected
38
Silent Detection
(TAM 1/F]
1 Off
Selecting whether or not the
machine will switch to fax com­
munication when a silent pause
longer than 3 seconds occurs in
the TAM/FAX mode.
2" On
NOT€
1, When parameter No. 13 is set to 1, you can still send document when your machine has no more recording paper,
or a mechanical error has occurred which affects receiving. Some transactions, however, may not be recorded on
the Journal when either situations occur.
2. Setting Number marked with an asterisk {') indicates factory standard setting.