Panasonic PVQ-V201 - Manual (Page 9)

‘Important: If a remote control button does not work when pressed, press
the VCR button on the remote and try the button again.
4 Press CHA Key to start Channel/Clock
Auto Set operation. Settings are
performed automatically. If the setup is
completed, the following screen is
displayed.
VCR I CLOCK I C hannel
r5/i372001 SUN 2:20PM
OSTrON
CH 10
AUTO CLOCK SET
completed
If “Auto Clock Set is Incomplete”
screen appears, set the clock using
MANUAL CLOCK SET procedure shown
below.
r VCR ' I CIOCK I CHANNB.
AUTO CLOCK SET IS
INCOMPLETE
PLEASE SET CLOCK BY
PRESSING ACTION KEY
<^o
S o o ©
S o © ©
O O
o ©
© ©
uomi
© O
o
icmni X ^ \ Pfloa
Manual ClockSet
POWER
VCR
VCR/TV
SELECT/
SET
A:PLAY
T :STOP
◄ :REW
► :FF
ACTION
CH A/T
If Auto Clock Set was incomplete, manually
set the clock as follows.
1
Press ACTION Key on the Remote to
display CLOCK Menu screen.
2
Press A T to select the month and ► to
set. In the same manner, select and set
the date, year, time, and DST (daylight
saving time).
VCR r&L'OCin channe TI
11/11/2001 SUN 12:00PM
3
SET COMPLETED
SET ►
START -ACTION
Press ACTION Key twice to start CLOCK
and exit.
Reset All VCR Memory Functions
Use when moving VCR to new
location, or if a mistake was made in
the Initial Setup section.
• Make sure a tape is not inserted in
the VCR.
1
Turn VCR
Power on.
2 Press and hold both
PLAY and CHANNEL
A on the VCR for
more than 5 seconds.
• The power shuts off.
3
Do “Initial Setup" on page 8.