Panasonic PVQ-V201 - Manual (Page 16)

Tape Operation
Search System
For each recording, an invisible index mark is placed
on the tape. A program index and information are also
included for timer recordings. These marks are used to
access or scan recordings.
Index Search
1
(NO£X iPflQGflAMEHQj
FOeWARO SEARCH :FT
REVERSE SEARCH :REW
next i SEARCH
EXIT ;STC3P
Press SEARCH*
to display SEARCH
in Stop or Play
mode.
INDEX SEARCH 3 Press number keys
to select recording
number.
• To calculate
number, see below.
Press FFor REW
to start search.
IHDEX SEARCH
Play begins at
search end. To
search forward or
back 1 index,
press FF or REW
while screen left
is displayed (10
sec.).
■ To Calculate Index Number
Example 1:
To go to rec. 2 from rec. 4, enter 3 and press REW.
Example 2;
To go to rec. 6 from rec. 2, enter 4 and press FF.
NOTE: i indicates start points of each recording.
If Index Search is started very close to
an index mark, that index mark may not
be counted in the search.
Program End Search
Locates end point of recording for
continuity.
Press SEARCH twice
to display SEARCH in Stop or
Play mode.
1
■SEARCH^__
J program i
SEARCH START:FF
EXIT__ ; SEARCH
Press FF
to start
PROGRAM
END SEARCH.
Examples of Program End Search.
Fiq.1
urrent tape po«t»
»SEARCH butio<
End Point
Fig. 2
[§]| PTOQmml II .BLANK ||§| Prognari
tape powDon V
End Point
Fiq.3
M>t laps poaldon
EARCH button
PiDgram 2
End Point
.^1
infL.
If search exceeds
a few seconds in
BLANKarea.
Upon locating end point,
-->search continues 7 sec. past end point,
">tape rewinds to 10 sec. before end point,
->tape plays to end point and stops.
^3^
• If Program End Search is started very
close to an index mark, that mark may be
skipped over.
• To cancel, press PLAY or STOP.
16
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]