Punch-in/out recording, Punch-in/out using the rec select switches, Footswitch punch-in/out – Yamaha MT100 User Manual

Page 19

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

PUNCH-IN/OUT RECORDING

Punch-in/out recording makes it possible to re-record a short segment of an otherwise perfect track in order to correct a mistake or

“brush up” an important passage. You "punch-in" at the point where you begin recording the new segment, and “punch-out” at the

end of the new segment so that the previously-recorded material is not erased.

Punch-in/out Using the REC SELECT Switches

1. Start the deck running — a few measures before the sec

tion to be re-recorded begins — in the record-ready mode

by pressing the REC button and then the PLAY button with
all track REC SELECT switches set to OFF. The red REC

LED will flash Indicating that the transport is in the record-
ready mode. The PHONES SELECT switch should be set

to MONITOR so you can hear all the tracks.

2. At a convenient break in the track switch the track to be

corrected to the record mode (punch-in by switching the

REC SELECT switch for that track to the appropriate rec

ord position) and start playing the new material to be re
corded. The REC LED will light continuously as soon as
the REC SELECT switch is set to a record position.

3. At the end of the re-recorded segment switch the track

back to the play mode (punch-out by switching the REC
SELECT switch for that track to OFF). The red REC LED

will begin to flash.

Footswitch Punch-in/out

1. Plug a YAMAHA FS-1 (optional) footswitch into the MT100

PUNCH I/O jack.

2. Set the .REC SELECT switch for the track to be punched-in

to the appropriate record position, and press the REC but
ton to activate the rec/pause mode. The red REC LED

should flash Instead of lighting continuously. If the red REC

LED lights continuously, press the footswitch once so that it

flashes; =

3. Press the PLAY button to start the transport running in the

record-ready mode.

4. Press the footswitch to punch-in. The red REC LED will

light continuously.

5. Press the footswitch a second time to punch-out. The red

REC LED will begin to flash.

TRACK 1

TRACK 2

TRACKS

TRACK 4

All tracks monitored In PLAY
BACK mode (the deck is In the

REC mode, but the track REC
SELECT switches are set to

OFF).

Begin playback

STOP

The record mode Is engaged for
track 3 only when the track 3

REC SELECT switch is set to

an ON position.

It's a good Idea to actually start playing a little
before the punch-in point.