Panasonic WV-CP160 User Manual
Panasonic, Vw-cp, Operating instructions
Table of contents
Document Outline
- Panasonic
- VW-CP160
- A!
- CAUTION
- 1. Do not attempt to disassemble the camera.
- 2. Handle the camera with care.
- 3. Do not expose the camera to rain or moisture, or try to operate it in wet areas.
- 4. Do not use strong or abrasive detergents when cleaning the camera body.
- 5. Clean the CCD faceplate with care.
- 6. Never face the camera towards the sun.
- 7. Do not operate the camera beyond the specified temperature or humidity.
- 0 Auto Iris Lens Connector
- 0 Flange-back Adjusting Ring
- d) Lens (Option)
- (D Camera Mounting Screw Hole
- (D Focus Fixing Screw ® Down Button ()
- ® Right Button ()
- ® Left Button ()
- ® Up Button (£®1)
- ® Set Button ([^)
- ®. ® Selector (NC)
- ® Detail Level Selector (SOFT-SHARP)
- ® Power indicator
- ® Monitor Output Connector (MONITOR OUT)
- ® Video Output Connector (VIDEO OUT)
- ® Rear Cover
- Basic System
- Caution:
- Cautions:
- Mounting from the top
- Caution on installation
- 1. CAMERA SETUP MENU
- 2. SETUP OPERATION
- To return to the CAM SET UP menu
- • All Reset Operation
- • Editing the CAM SET UP Menu Important Notice:
- • Editing the SPECIAL Menu
- 1. Camera Identification (CAMERA ID) Setting
- 2. Light Control Setting (ALC/ELC)
- 4. Gain Control Setting (AGC ON/OFF)
- 5. Electronic Sensitivity Enhancement (SENS UP)
- Notes:
- 6. White Balance Setting (WHITE BAL)
- 6-1. Auto-Tracing White Balance Mode (ATW)
- Fine Adjustment for AWC (ATW) Manually
- 7. Special Menu
- 7-1. Camera Picture Upside Down Positioning (UP SIDE DOWN)
- 7-2. Chroma Level Setting (CHROMA GAIN)
- 7-3. Aperture Sharpness (Softness) Setting (AP SHARP/AP SOFT)
- 7-4. Pedestal Level Setting (PEDESTAL)
- 7-5. Chroma Phase (Hue) Setting (HUE)
- To reset to the factory settings (CAMERA RESET)
- To close the SPECIAL menu and return to the CAM SET UP menu
- To close the SPECIAL menu and return to the camera picture
- CAUTION