Panasonic WV-CP160 - Manual (Page 17)

3. When the white balance setting is completed, the PUSH SW returns to normal display.
Note: In case that the white balance is not set, the PUSH SW is being highlighted,
4. When you want to adjust the white balance manually, press to select AWC and
press El. The AWC menu appears on the monitor. (When ATW is selected, pressing
E] displays the ATW menu.)
** CAM SET UP **
CAMERA ID OFF T
ALC/ELC ALC T
SHUTTER OFF
AGC ON
SEHS DP OFF
WHITE HAL APfC
END SET DP ENABLE
J
>
Ik* AWC **
R
pT.:,;i.r:Tq
+
В ___ 1,.,.
+
MASK SET T
RET END
V____ ______________ /
Fine Adjustment for AWC (ATW) Manually
You can add the detailed setting for white balance setting manually,
1, To set MASK SET, proceed as described in steps 2 to 4 of "ALC mode with SUPER-D2
OFF and ELC mode",
2, Move the cursor to R,
3, Press d or E to obtain the optimum amount of red gain,
4, Move the cursor to B.
5, Press ^ or Q to obtain the optimum amount of blue gain.
Note: When you need to set MASK SET, re-adjust to obtain the optimum amount of red and
blue gain.
7. Special Menu
This menu lets you adjust and set
up the video signal of the camera
to meet your requirements.
Move the cursor to END on the
bottom line of the CAM SET UP
menu and press ^ and ^
simultaneously (holding down ^
and press [^) for 2 seconds or
more. The SPECIAL menu ap­
pears on the monitor as shown at
right.
f -------------
** CAM SET UP
**
CAMERA ID OFF
n
ALC/ELC ALC
T
SHUTTER OFF
AGC ON
SENS DP OFF
WHITK &AL AWC
“1
Etml SET UP ENABLE
—
----
** SPECIAL **
DP SIDE DOWN OFF
CHROMA GAIK ___ I
AP SHARP ... .1
PEDESTAL .1. . .
HUE .1. . •
CAMERA RESET 4PUSH SN
RET END