Panasonic WV-CP160 - Manual (Page 10)

2. SETUP OPERATION
This camera utilizes a user setup menu
(CAM SET UP) that is displayed on the
monitor.
To set items on the CAM SET UP menu, use
the following buttons on the side panel.
Button
Set Button
--------------Up
Button
[r^—Right
1!=^ Button
Up Button ):
Down Button
Right Button ([^):
Left Button ( ^):
Set Button (Csl):
--------- Down
Button
Moves the cursor
upwards. Use this button to select an item or adjust the parameters.
Moves the cursor downwards. Use this button to select an item or
adjust the parameters.
Moves the cursor to the right. Use this button to select or adjust the
parameters of the selected item. The parameter changes each time
this button is pressed.
Moves the cursor to the left. Use this button to select or adjust the
parameters of the selected item. The parameter changes each time
this button is pressed.
Executes selections and displays a submenu for an item with n mark.
END: Close Setup menu.
RET: Return to the previous menu.
To return to the CAM SET UP menu
Move the cursor to RET and press El. The CAM SET UP menu appears.
• All Reset Operation
All Reset allows you to reset all setup menu items to the factory default settings if you are
unsure about the correct settings. Proceed as follows:
(1) Make sure that the CAM SET UP menu is not displayed (a camera picture is displayed).
(2) While pressing both ^ and [^, press ts] for a few seconds. The message ALL
RESET momentarily appears on the monitor.
This resets all adjustments and parameters to the factory default settings.
• Editing the CAM SET UP Menu
Important Notice:
When the SET UP DISABLE appears in the bottom line of the CAM SET UP menu, you
cannot change the currently active settings. This is to prevent accidental changing of
the settings
To edit the CAM SET UP menu (change
settings),
press and ^ or ^
and to move the cursor to SET UP
DISABLE in the bottom line.
Press El. SET UP DISABLE changes
to SET UP ENABLE. Move the cursor to
END, then to the item(s) you want to
change.