Panasonic KX-T2396BA - Manual (Page 9)

Troubleshooting guide inserting the tape
Problem Cause & Remedy
The unit does not work when 1
press any buttons. • Plug in the AC adaptor again.
•The unit is turned off. Press the
ANS SYS ON/OFF switch to turn
on the unit.
The unit does not ring. •The RINGER selector is set to the
“OFF” position. Set it to the
“HIGH” or “LOW" position.
i try to store the telephone number
into memory station, but the
storing procedure cannot be done.
• Be sure that the AC adaptor is
connected and handset is on the
cradle.
The Outgoing Message is
recorded improperly.
• Record a new Outgoing
Message.
•Clean the heads. (See page 42.)
When 1 press the OGM REC
button to record my Outgoing
Message, the unit does not start
recording, and a beep sounds
6 times and the ANS/CALLS
indicator flashes. •The cassette tape might be
broken. Replace it with a new
one.
When 1 record an Outgoing
Message, a beep sounds 6 times
and the unit stops recording. • Re-record your Outgoing
Message. Speak clearly and
loudly, and do not pause for over
2 seconds while recording.
Cassette tape compartment is covered.
2
open the cassette panel.
Remove the stopper of the
cassette tape.
Insert the cassette tape.