Panasonic RX-DT770 - Manual (Page 14)

j^ogramming Broadccist Stations
Once broadcast stations have been programmed, they can easily be tuned in at the touch of a button on the unit or on the remote control.
Up to ten FM and AM stations each can be programmed.
Example; Programming FM 88.1 MHz in preset channel 2.
TUNER/BAND
- TUNING +
MEMORY
Press TUNER/BAND to dis­
play “FM” or “AM”.
(The display changes each time the but­
ton is pressed.)
Press - TUNING + to tune in
the broadcast station.
FM stations can be selected automati­
cally (see the right).
Press MEMORY.
MEMORY While ¡PROGRAM I is flashing,
press MEMORY.
Repeat steps 2 to 5 to pro­
gram the other stations.
Selecting FM stations automatically:
Keep pressing - TUNING + until the frequency display starts to
change. A station with good reception is automatically selected and
the selection process then stops.
To stop the selection at any time:
Press - TUNING + again.
The selection may stop without tuning into any station if there is
interference in the vicinity. In such case, tap - TUNING + until a
station’s frequency is picked up.
Programming AM stations:
1. Press TUNER/BAND in step 1 to display AM.
2. Perform steps 2 to 5.
V preset TUNING A While I PROGRAM I is flashing:
Press V PRESET TUNING A
to display the preset channel
in which the station is to be
programmed.