Panasonic NV-L20 - Manual (Page 13)

Setting the Clock to the Present Tíme Using the Bar
Codes
- II
HI ml «1 r 11
-Z in »= 'll I ril
«1. jn mZ >11 I in
•r 111 -= m I m
mZ in «1 I iW
mz HI Mr IW I m
•r nil m : m Z HI
mZ «« Ml IÍ 1 III
■r 1M m : III Ì 'HI
-r «1 M-, III T II
>Z «1 *>r áH 1 111
mz III I III
Preparation
•Slide down the Mode Selector Cover on the Remote
Controller so that the Bar Code Reader Display can be
seen.
•Press the Digital Scanner On/Off Button to turn it "ON".
o
Trace the bar code "SETTING OF THE CLOCK”.
—
SETTING OF THE CLOCK
@ Trace the bar code for the year (YEAR).
0 Trace the bar code for the month (MONTH).
Q Trace the bar code for the day of the month (DATE).
0 Trace the bar code for the hour (START TIME).
(3) START TIME
3 G0
9 B-
© Trace the bar code for the minute (MIN).
MIN
tn
•u
© Press the Transmit Button on the Remote Controller
and then confirm that the time is displayed in the
Multi-Function Display of the VTR.
O Press the Digital Scanner On/Off Button to turn it
“OFF".
•If the transmission was not received correctly, the
“Beep-Beep, Beep-Beep" sound from the VTR wilt warn
you. In this case, perform transmission again.
•If the Remote Controller is left with no operation per­
formed for more than 4 minutes, it will automatically switch
over to the power-saving standby condition and the lamp
in the reading tip goes out. In this case, bar codes that
have already been read (but not yet transmitted to the
VTR) will be cancelled.
•The bar codes "SETTING OF THE CLOCK", “YEAR" and
"MONTH" are located on page 3 of the Programming
Sheet.
13