Precautions – Panasonic WJ-MX30 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PRECAUTIONS
The WJ-MX30 is a sensitive, high quality instrument and should be treated with care. Because it is an electrical device, the danger
of electric shock exists if it is used inappropriately.
DON'T
DO'S
Do not attempt to disassemble the instrument. In order
to prevent electric shock, do not remove screws or
covers. There are no user-serviceable parts inside.
Do refer all servicing to qualified service personnel.
X
Do not abuse the instrument. Avoid striking, shaking,
etc. It could be damaged by improper handling or
storage.
X
Do not use strong or abrasive detergents when
cleaning the instrument body.
• Do handle the instrument with care.
Do use a dry cloth to clean the Instrument when dirty.
In case the dirt is hard to remove, use mild detergent
and wipe gently.
X
Do not expose the instrument to water or moisture, and
do not operate it in wet or humid areas.
Do take immediate action if the instrument becomes
wet. Turn power off and refer servicing to qualified
service
personnel.
Moisture
can
damage
the
instrument and also create a danger of electric shock.
X
Do not use the instrument in an extreme environment
on
extremely high temperature or high humidity.
• Use the instrument under ambient conditions of
0°C
to
40°C
in temperature, and below
90"/o
in humidity.
IMPORTANT POINTS FOR VIDEO INPUT SIGNAL
(1) Failure of input video signals to meet the NTSC color
standard can cause a disturbance of synchronization.
(The picture may jitter or tear)
(2) A very low input signal to noise ratio (S/N) may result in
a low quality picture.
(3) A very jittery source input video signal, for example, a
poor VTR playback signal can cause a disturbance in
synchronization or color.
(4)
Tracking noise on the TV monitor can cause a
disturbance in synchronization. It is necessary to adjust
the tracking control of the input VTR.
(5) When either a character generator signal or character
input from a key camera is supplied, the edge of the
characters might become rough as shown below under
certain electronic conditions.
(
6
)
Flag waving (top of picture curls) may appear when a
certain VTR is used to supply input signal, (due to AFC
time constant)
(7)
When an external key video signal is supplied to
the EXT. CAMERA IN connector, it will be used as
a reference sync signal for the WJ-MX30. A jittery
VTR playback signal, if used as such, can cause a
disturbance in synchronization.
-2-