A-1. power field preset operation mode, A-2. reset factory preset operation mode, Operation – Panasonic WJ-MX30 User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

OPERATION

Pre-Operational Setup

A-1. Power ................. Field Preset Operation mode

1. Press the MAIN POWER Switch (98) on located on the

rear panel. The unit is now in stand-by mode. No
operations can be executed yet.

Notes :

•

When turning off te MAIN POWER Switch with

the POWER switch ’’OFF", this unit is stand-by
condition by turning on the MAIN POWER switch.

• When turning off the MAIN POWER switch with the

POWER switch ”ON’’, this unit is on condition by

turning on the MAIN POWER switch if the memory

backup is kept.
In this time, if the memory backup is not kept, this
unit is stand-by mode.

Press the Power On/Off Button (1) on the operation
panel. The unit is now in operation mode and the
Cooling Fan (97) located on the rear panel starts to
rotate. The LED’s on the operation panel light up as
shown below.

Notes :

1. If you do not use the unit for an extend period of

time or to shut off the power completely, switch
off the MAIN POWER Switch (98).

2. If the Cooling Fan (97) does not rotate, switch it off

and disconnect the AC power cord. Call service
personnel before attempting further use.

3. The modes selected by buttons will be kept by

memory backup approximately 1 week even if AC
power is disconnected.

A-2. Reset ...............Factory Preset Operation mode

Press the Power On/Off Button (1) off. With both the Color-A

(49) and B (50) Buttons depressed, press the Power On/Off

Button (1) on.

It would be helpful in case of unexpected operational failure.

B '

3. And this status, without still and strobe, is later recalled

when the power is restored if the memory is kept.