Audio/video connections, Stereo amplifier connections – Panasonic PV-4651 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Audio/Video Connections
If your TV has AUDIO IN and VIDEO IN terminals, you can connect your VCR to them to receive a higher quality
picture and sound. The antenna-VCR and VCR-TV connection is as shown.
VHF/UHF
VIDEO IN
1
Connect the VIDEO OUT terminal on the VCR to the VIDEO IN terminal of your TV.
2
Connect the “L" and “R” AUDIO OUT terminals on the VCR to the “L” and “R" AUDIO IN terminals of your TV.
3
Set the VIDEO/TV selector of your TV (Monitor/Receiver) to “VIDEO.”
NOTE: To use your TV as a VCR monitor, set the VIDEO/TV selector on the TV (Monitor/Receiver) to “VIDEO."
{- Stereo Amplifier Connections
When you connect your VCR
to a Stereo Component
System, you can view the
picture from the VCR while
enjoying stereo from your
audio system.
Connect the “L" and “R”
AUDIO OUT terminals on the
VCR to the “L" and “R” AUDIO
IN terminals of your stereo.
VCR
Note to CATV system inst^ler:
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC in USA (and to the
Canadian Electrical code in Canada) that provides guidelines for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.