Panasonic PV-4651 - Manual (Page 12)

ni Qn Screen Displays (OSD)
Function & Channel Display
Whenever a function button
is pushed (PLAY, FF, etc.)
or the channel is changed,
a 4 second OSD will
appear first in large and
then small characters.
................... - MENU ..... .................-
SET UP VCR
—
UPOTANNEL
IDIOMA/ LANGUE: ENOLI SH
Menu Screen
1
Push MENU to display the
menu.
2
Rotate and push the wheel
to make your selection
(see page 10).
To get the most from each feature, it is
recommended that you read the Operation
Manual before attempting any operation.
SELECT
SET
END ROTATE WHEEL
PUSH WHEEL
PUSH MENU KEY
Warning and Instruction Displays
These displays will alert you to a missed operation or
provide further instructions.
if no active channels are
found for CHANNEL
MEMORY...
If you attempt to set or
review a Timer Recording
and the Clock is not set...
NO CH FOUND
PLEASE CHECK ANTENNA
CABLE CONNECTION THEN
PUSH VCR CH UP KEY AGAIN
PLEASE SET CLOCK
BEFORE PROGRAMMING
If a Timer Program was not
completed before exiting
the Program mode...
PROGRAM IS INCOMPLETE
VCR Status & Clock Display
Push DISPLAY to display and remove the
overlay shown below.
After a Timer Program has
been set...
TURN VCR OFF
FOR TIMER RECORDING
Function Status Time
J____ L_
RecTime -
Remaining
(OTR mode only
see page 14.)
Receivable
Broadcast Types
(See page 22.)
REC 12:00AM CMOS
•0:25 0:00:00
STEREO / SLP
, SAP
MONO
Channel
Counter Tape Speed
Blank Tape and will be Blue Screen
If a blank section of tape is encountered in the Play
mode or the channel you select has no broadcast,
the TV screen will change to a solid blue field.
The screen will remain blue until a recorded signal
is again detected or an active channel is selected.
If you push REC on the
remote control or REC
and PLAY on the VCR,
and a cassette is inserted
with no record tab...
if you push PLAY. FF. REW,
or REC on the remote control
or if you push REC and
PLAY, PLAY, FF, REW, or
REC on the VCR without a
cassette inserted...
If you push POWER or
STOP during a Timer
Recording...
(visible in VCR mode only)
CHECK CASSETTE
RECORD TAB
NO CASSETTE
PLEASE INSERT A CASSETTE
TO CANCEL TIMER REC
PUSH POWER THEN STOP KEY
12