Panasonic PV-4651 - Manual (Page 20)

Timer Recording Using VCR Buttons
A timer recording can be set up using the
buttons on the VCR. If necessary, the clock
can also be set.
©
Hold down
REC/TIME.
and
Push FF to
enter the
program mode.
START STOP CH
ELECT START DATE
BY SELECT A/T KEY
NEXT. PUSH SET KEY OR
TO END PUSH PROG KEY
-V|y-- SET CLOCK---------------
DSTrON If the clock Is not set, pushing these
buttons will display the SET CLOCK
screen. In this case, proceed with
steps 2 and 3 to set the clock and then
steps 2-6 to set a timer recording.
Once the VCR is in the Program mode, the PLAY, REC, FF,
and REW buttons on the VCR operate only as specified above.
ÉÌÌEDÌS3Ìàà"
BY SELECT A/T KEY
NEXT, PUSH SET KEY OR
TO END PUSH PROG KEY
©
or
c
Push REW or PLAY to
^ make your selection.
(for down) (for up)
©
Push FF to set
and move on to
the next item.
Push SET (FF) repeatedly to
move to a particular item for
setting or correction.
Items to be Set:
• recording DATE
• START time
• STOP time
• CH(annel), or LINE
• SPEED (SP, LP, SLP)
When the program is completed...
^ 3 ^ and (Q
Push REC/TIME
and FF to display
program contents.
(at the same time)
To set the next program,
repeat steps 2, 3, and 4 before continuing with step 5.
and
©
Push RECn*IME and
FF to exit this mode.
(at the same time)
Push POWER off
to set the timer.
-oma-
Multi Function Display
It is not possible to clear a timer program using the VCR
buttons. Please use the Remote Control.
When recording programs via a cable box, make sure the
cable box is left on and tuned to the desired channel.
20