Panasonic KX-TG2650N - Manual (Page 62)

Before Requesting Help
Problem Remedy
The handset or base unit
display goes to the standby
mode while viewing the
Caller List.
•Do not pause for over 60 seconds while
searching.
•i^. rè~1 or [DIGITAL SP-PHONEl.
was pressed.
When a second call is
received during a
conversation, the unit does
1 not display the new caller’s
1 name and/or phone number.
•The line mode selection is incorrect. See
page 14.
1 You cannot page the
j
handset or the base unit.
•The handset is too far from the base unit.
•The handset or the base unit is engaged
in an outside call or is viewing the Caller
List/directory list. Try again later. If you
are using the base unit, wait until
“Handset in use”
disappears.
You cannot redial by
pressing iREDIAL/PAUSEl or
IREDIALI.
]
•If the last number dialed was more than
32 digits long, the number will not be
redialed correctly.
•Access numbers entered after pressing
iTONEl will not be included when
redialing.
•The [REDIAL/PAUSEl button on the
handset has a double function as either
redial or pause. It will redial the last
number dialed if pressed at the outset of
a call (p. 20). If another number has
been dialed first, it will operate as a
pause button (p. 49).
“Recharge battery”
is
displayed on the handset,
“t ■ 1” flashes or the unit
beeps intermittently.
•Charge the battery fully (p. 11).
You charged the battery
fully, but
“Recharge
battery”
is Still displayed
and/or “ i i ] ” continues to
flash.
•Clean the charge contacts and charge
again (p. 12).
•Install a new battery {p. 58).
62