Panasonic KX-TG2650N - Manual (Page 47)

To erase a stored number
Press and hold [CLEAR/INTERCOMl in step 6 on page 46.
•You can exit the programming mode any time by pressing (OFF).
Setting the Voice Maii Tone
If your voice mail service sends a voice mail tone after a new message has
been recorded, set to “On”,
“voicemail”
and “ISl ” will be displayed and
the VOICE MAIL button on the base unit will flash when a message has
been recorded in your mailbox. You will hear a series of voice mail tones
followed by a dial tone after pressing S).® or I DIGITAL SP-PHONE].
{Contact your service provider for details about your service.)
Set to “Or if;
—you do not subscribe to a voice mail service,
—your voice mail service does not send a voice mail tone, or
—the unit is connected to a PBX.
Your phone comes from the factory set to “On”.
Make sure the unit is in the standby mode initially.
1
2
3
4
Press iFUNCTION/CHl.
Press ® 01' ® repeatedly until the arrow
points to
“Program”.
Press B
(Yes
key).
Press B or ® repeatedly until the arrow
points to
“Voicemail tone”.
Save mailbox#
► Voicemail tone
T A ^=Yes
Press 0
(Yes
key).
Voicemail tone
:0n
TA ► =Save
Press ® or ® to select “off” or “on”.
Press ®
(Save
key).
•A beep sounds. ____
•To return to the standby mode, press [OFFl.
»You can exit the programming mode any time by pressing lOFF).
47