Panasonic PANAFAX UF-321 - Manual (Page 45)

Sending Documents
To dial the telephone number manually, follow the steps below.
Manual Number Dialling (ADF Transmission)
1
Set document(s) face down.
DOCUMENT SET
ENTER STATION 00%
2 MEMORY
a I I
Make sure that the lamp is off. If not, press ГМЕМОВУ"
to set "off”.
3
4
Ш
Enter a telephone number from the keypad.
Ex: Ц] IS ОШЕ] Ш SI
Ф START
PRESS START TO DIAL
55512341
* DIALLING
55512341
Your machine starts to dial the telephone number.
Note: 1. If you need a special access number to get an outside line, dial it first then press \ PAUSE I to enter a
pause (represented by a ”-) before dialling the full number
Ex: 9 PAUSE 5551234
2. If you are using Pulse dialling and you wish to change to Tone dialling in the middle of dialling, press
I TONE i (represented by a T).
The dialling mode will be changed from Pulse to Tone after dialling the digit T.
3. To stop the transmission, press I STOP I .
The display shows;
COMMUNICATION STOP?
1:YES 2:NO
Press [T] fo stop the transmission.
4. If you hear the voice of the other party through the monitor speaker after last step, lift the handset of
your external telephone and press I STOP I and{J] to stop the communication. Then press
I STOP I to stop the alarm. When you hear the beep after telling the other party to prepare to receive
the document, press I START i to start fax communication.
43