Press tuner, Direct tonino press direct tunìng, Band press band to select “fm”, 1 “mw”or“lw – Panasonic SAGX690 User Manual
Page 14: Press vor a to tune to the i desired broadcast, When the fm stereo broadcast is received, If noise is excessive in the fm stereo mode, To change the mw frequency step, N n o n
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Direct access tuning
Specify the frequency using the numeric buttons to directly tune
to the desired broadcast station.
W
TUNER
Press TUNER.
g/
BAND
Press BAND to select “PM”,
Lights up
DIRECT TONINO
Press DIRECT TUNÌ
n
G.
< 7
—‘f=i----------------------------------
Flashes
While cursor display is flashing
{approx. 10 seconds)
g?
1 1
[ 2 1 3
i\q~ol^Press
the
appropriate
numeric buttons to enter the
frequency.
If the desired FM frequency is 107.90 MHz
<0
QUARTZ LOCO
-----------------
I n n o n
f U f.-IU
h
Lights up when tuned
If the frequency has been input correctly, the
displayed frequency will biink once.
1. If no button is pressed while the cursor display is flashing, the
display will return to the frequency which is currently being
received. To re-specify the frequency, repeat the procedure
from step 3.
2. if the frequency has not been input correctly, “ERROR" in
dication will be displayed. In this case, re-enter the frequency.
14
Sequential tuning
If the frequency is not known, use the tuning buttons to search for
it.
2 3
W
TUNER
Press TUNER.
BAND
Press BAND to select “FM”,
---------- 1 “MW”or“LW”.
(For Australia and NX: FM or AM)
b
T]
Lights up
m
V TUNING .A.
Press vor
A
to tune to the
I desired broadcast.
If either button is held down for an ins
tant until the frequency begins to
scroll, the broadcast stations can be
tuned in automatlcaily when a broad
cast station is found.
Tuning may stop automatically if any
jamming is encountered.
When the FM stereo broadcast is received
This unit will automatically switch to FM stereo reception and the
"STEREO" indication will light up.
aiMiniLocK
ÌTÈRÈ0
/ n n o n
I U i J U r n
Lights up when a stereo broadcast is tuned in
If noise Is excessive In the FM stereo mode
Press FM AUTO/MONO. (The FM stereo indicator will switch off.)
The broadcast will be monaural, but noise will be reduced. If the
button Is pressed once more, the stereo mode will be resumed.
To change the MW frequency step
Press and hold BAND for about 3 seconds.
(The frequency step changes to 10 kHz per step.)
To return to the previous step, press and hold BAND for about 3
seconds again.