Panasonic PV-4611 - Manual (Page 16)

Timer Recording
Your VCR can be set up to do a recording
while you are away or otherwise occupied.
Up to 8 programs can be placed in
memory. You can choose to record one
time, daily, or weekly.
[^^heck list before you begin.
□ All connections are made.
(See pages e-S.)
□ TV and VCR are plugged in and turned on.
□ VCR/TV selector is set to “VCR."
I I Clock is set to correct time.
I I Record tab in place.(See page 5.)
f " ""'i
Cp o o o e CE) ••
^ •
k—^ ir
Multi Function STOP/EJECT
Display
PROG
Push PROG to display
the program screen.
• If a program is already in
memory, use the Wheel to
select an unused program
number.
START STOP CH
SUP
Rotate and push the
WHEEL to select and
set the DATE.
Today’s Date
1
.WEEKLY(SA1><—7-*-8-9
WEEKLY
(MCtJ)
Example
Wheel Selection Order
WEEKLYiSUN)------------ DAILY—6-
Daily and Weekly Timer Recording
If you want the program to be recorded daily
(Mon thru Fri) , enter DAILY in place of the
DATE in step 2. If you want the recording to
be on a weeWy basis, enter WEEKLY MON,
TUE, etc..
Important notes when using a
DSS receiver
• When recording programs via a
DSS receiver, the DSS receiver
must be left on.
• When recording programs via an
antenna or cable, the DSS receiver
must be turned off.
(D
Rotate and push the
WHEEL to select and
set remaining items at
right.
Remaining items
to be set:
• START time
• STOP time
• CH(annel) number,
or LINE for outside
source recording.
• speed (SP, LP, SLP).
To Make Corrections
Repeatedly push the Wheel to move forward, or the CLEAR button to
move back to the desired item. Then, select and set continue with step 3.
PROG
Push PROG to end
the program.
• If you want to enter more
programs, select a blank
program number with Wheel
and repeat steps 2 and 3.
P DT STRAT STOP CH SPD
2------------------
3
-------------
4 —
SELECT
ENTER
CANCEL
END
-8: R01
PUSH V
PUSH C
PUSH
FATE WHEEL
ÌHEEL
:LEAR KEY
HOG KEY
Push PROG to exit
o this mode.
PROG
Push VCR POWER
off to set the timer.
* When recording programs via
a cable box, make sure the
cable box is left ON and tuned
to the desired channel.
Muiti Function Display
If the cassette record tab is missing at the time the VCR power is turned OFF, the tape ejects and
the TIMER indicator flashes.
If the start times of two programs overlap, the lower numbered program will have priority.
If the start time for a timer recording comes up during a normal recording or One Touch Recording (page 15),
the timer recording will not be performed.
If there is a power interruption of more than one minute, the recording not be performed or continue.
If "PROGRAM IS INCOMPLETE” appears on-screen in step 4, check alt entries and make necessary corrections
16