Panasonic KX-RC95 - Manual (Page 50)

Troubleshooting Guide
When trouble occurs, check the following points before returning CPA for
service
Trouble Cause Procedure
Press a key but
nothing appears on
the display
CPA IS not turned on Turn the power switch on
(See p 13)
Press a key but
nothing enters
The bottom cover is
open Close the bottom cover
(See p 15)
Turn on the power
switch, but nothing
appears on the
display The battery is not
charged Charge the battery for
about three (3) hours
(See p 11)
The battery pack is
not installed
Install the battery pack
(See p 56)
The protective sheet
has not been
removed from the
battery terminal
Remove the protective
sheet (See p 5)
The power switch is
not operated
correctly
Try turning on again
following procedure on
p 13 If nothing appears
on the display, press the
reset switch with the tip of
a ball-point pen (p 53)
then slide the power
switch again
The remaining
battery amount is
incorrectly displayed
The battery has
become inactive
Keep operating CPA until
“WEAK BATTERY” is
displayed then recharge
the battery (See p 11)
The display shows
"INSERT AC
ADAPTOR" and
CPA will not accept
any key function
The battery is empty Plug in the AC adaptor
and charge the battery for
about three (3) hours
(See p 11)
Troubleshooting (continued)
50