Panasonic KX-RC95 - Manual (Page 49)

Transferring Data
On CPA-b:
Receive the data.
[ CODE ENTER ]
(Select RECEIVE)
or ENTER]
(Select Y)
On CPA-a:
Send the data.
[ENTER]
RECEIVING . . .
PRESS DONE KEY TO EXIT
CPA-b is ready to receive the
data.
SENDING . . .
PRESS DONE KEY TO EXIT
•Press [ ENTER ] within 30
seconds, or “LiNK ERROR”
wiii occur.
•To stop transferring data,
press [DONE] on either CPA-a
or CPA-b.
The data on the way is
transferred to CPA-b (receiver).
FEB.25,1994 FRI
09:12 PM
© On both CPAs
Return to initial display.
[DONEMDONE]
(S^ •Before starting the transfer, make sure that the memory size of CPA-b
is larger than the existing data size of CPA-a. If not, the existing data
of CPA-b will all be cleared. If necessary, delete some records in
CPA-a.
• If KX-RC100 is the sender, the data of Second Bank, Cash, Card
#6—10 and Phone will not be sent to CPA (KX-RC95).
• If KX-RC105 is the sender, the data of Second Bank, Cash and Card
#6—10 will not be sent to CPA (KX-RC95).
• "LINK ERROR” will occur in the following cases:
1. If the baud rate is different between the CPA units.
2. If the CPA units are not connected correctly by the interface cable.
3. If address data is sent to a CPA which has phone data.
4. If phone data is sent to a CPA which has address data.
•Withdrawals and service charges are entered on a KX-RC100/105 by
entering 0 as the check number. When this data is transferred to a
KX-RC95 it will be included when you make a report and select the
check number as “A”, “S” or "O” (p. 24, 41). To search for this type
of record on a KX-RC95, press [ FIND ] and enter “0” as the check
number (p. 28). 49
0)
(Q
a
09
Q)
s
a
(A
I
(Q
S’