Panasonic KX-RC95 - Manual (Page 48)

Transferring Data
Setting the Link Parameter
Before transferring data, both CPAs must be set to the same baud rate (baud
rate of 9600 is set at the factory).
Operation
® Select the baud rate (Example: 9600).
[ SETUP ]-^r^ twice-^ENTER]
(Select LINK)
Display/Description
BAUD : 2400 4800 1600
Confirm the other parameters.
[ ENTER l-»(y| or®
09
3
0)
Z. (3) Return to initial display,
(g [ ENTER M DONE]
a
09
09
0 Set the same baud rate of the other
CPA in the same way.
Performing the transfer
PARITY: NONE STOP : 1 BIT
LENGTH : 8BITS O K N / 0 ?
Parity bit: no parity
Stop bit: 1 bit
Data length: 8 bits
•These parameters are for
communication with a personal
computer.
FEB.25,1994 FRI
08:38 PM
^ Note: When receiving data, all existing data is deleted.
(Q
s-
Example: You want to transfer all the data from CPA-a (sender) to CPA-b
(receiver).
Operation
© On CPA-a:
Select item to be sent (Example: ALL).
i CODE l-^n^fENT^
(Select SEND)
48
Display/Description
CHECK
CARD ADDRESS