Panasonic PV C1322 - Manual (Page 23)

Cancel a Timer Recording:
(Recording is in progress)
Hold down STOP for a few seconds
to cancel the Timer Recording,
• Any future daily or weekly recordings
will be performed as programmed.
ADD/DLT
SELECT/SET
A ;CH UP
▼ :CH DOWN
► :VOL UP
◄ :VOL DOWN
PROG
STOP
Review, Replace or Clear Program
Contents : (Recording is not in progress)
Repeat steps 1 and 2 on page 22.
e 10:OOa12;OOp12S
3 10 8:00p 9:00p 10
4 SO 9:00p10:00p L
CANCEL lAOD^DLT
SELECT 1
-acA T
ENTER >
END :PROG/ACT(ON
Press AV to select
the desired program.
To Replace program...
1) Press ►to display.
2) Press AT to select
and press ◄ or ►
to set new program
contents.
3) Press PROG (or
ACTION).
START STOP cm ]
8SA19:OOP 12:00A 08
ABC
CATEGORY:MOW IE SP
SELECT:A T
SET
:
M
►
1
END :PROG/ACTION
__ ,
To Clear program...
Press ADD/DLT. P DT START STOP CH SPD
2 B 10:00p12:00a125 SP
3 10 8:00p 9:00p 10 SP
4 Sit 9;00p10:00p L LP
SELECT 1-8:A T
ENTER :»
END
:PROG/ACTION
Press PROG twice (or ACTION)
to exit this mode.
• 2 minutes before Timer recording is performed,
“PLEASE PREPARE FOR TIMER REG” appears and/
or the PROG TIMER Indicator flashes. Be sure a
cassette with record tab is loaded and the unit is in
Stop mode.
• If the start times of two programs overlap, the lower
numbered program will have priority.
• If the start time for a Timer Recording comes up during
a normal recording or One Touch Recording {page 12),
the Timer Recording will not be performed.
• If there is a power interruption of more than one minute,
the recording may not be performed or continued.
• If “INCOMPLETE” appears after all items have been
set, check all entries and make necessary corrections.
23