CANOGA PERKINS 9135 SNMP Managed 10/100/1000 Ethernet Switch - Manual (Page 24)

EdgeAccess Universal Chassis System
Model 9135 10/100/1000 3-8
Slip Port Settings
Terminal Type: : VT100
1. Interface
2. Init Modem At Startup
3. Modem Init String
4. Password Enable
5. Password
6. SLIP IP Address
7. SLIP Subnet Mask
8. SLIP Port Setup
9. Main Menu
Figure 11. SLIP Port Settings Menu
Table 10. SLIP Port Settings Options
Menu Item Description
1. Interface Select Direct, for SLIP mode, or Modem
2. Init Modem at Startup Select yes or no
3. Modem Init String
The default string is ats0=1; do not change unless Canoga Perkins
technical assistance advises
4. Password Enable Select yes or no
5. Password Enter a password for SLIP mode, up to 15 characters
6. SLIP IP Address Enter the IP address for SLIP mode
7. SLIP Subnet Mask Enter the Subnet Mask for SLIP mode
8. SLIP Port Setup Opens the SLIP Port Setting menu; set values for these parameters:
Baud Rate; default is 9600
Parity; default is None (N)
Stop Bits; default is 1
Flow Control; default is None (N)
9. Main Menu Return to the Main Menu
3.4.4 Passwords
The 9135 provides three levels of password protection:
• Supervisor: highest level, controls all menu functions
• Manager: middle level, has some write access
• User: lowest level, mostly read-only, can reset some counters
To set a password, see Figure 12 and follow these steps:
1. From the System menu, type
4
, Passwords, and press .
2. At the Passwords menu, type the number for a user level and press .