Casio Cassiopeia PA-2400 - Manual (Page 32)

32
If mode specification is omitted, the normal mode with the connection-wait time-
out set to 1 minute is automatically specified.
Table 3.8
Connection-wait time-out Start Communication partner
1 minute Infinite
Idle (including script) PC (I/O Box)/HT
PC (I/O Box)
No mode
specification Mode
specification
, "I"
Designation of operation
command
HT Mode
specification,
"H"
-
Examples:
FLCE /Y={COM1, 115200, } /S "
casio*.dat" "d:casiodat"
Communication is performed using the RS-232C port at a baud rate of 115.2 Kbps. (Connection-
wait time-out is 1 minute.)
FLCE /Y={, , I} /S "
casio*.dat" "d:casiodat"
Communication is performed through command specification with the device name and the baud
rate is default-set.(Connection-wait time-out is infinite.)
FLCE /Y={, , H} /S "
casio*.dat" "d:casiodat"
Communication is performed between two host PCs through command specification with the device
name and the baud rate is default-set.(Connection-wait time-out is 1 minute.)
FLCE /Y={, , I}
Communication is performed in the idle mode with the device name and the baud rate is default-set.
(Connection-wait time-out is 1 minute.)
FLCE /Y={, , } /S "
casio*.dat" "d:casiodat"
Communication is performed under the same conditions (using default values) when "/Y" is omitted.