Casio Cassiopeia PA-2400 - Manual (Page 31)

31
3.12 Details of Functions
FLCE /Y
< Description >
Used to set up the device, baud rate, and communication mode used for communication.
If this command is omitted, the default value {IrDA, 115200, } is used.
Any of the parameters can be omitted. If this is done, the default value for each parameter will
be used.
Always insert this command directly after FLCE. Placing it in another place will result in a
parameter error.
< Format >
FLCE /Y={ [], [], [] }
(Parameters in [ ] can be omitted.)
< Parameter >
Device
Select either "IrDA" or "COM1".
Baud rate
If "IrDA" is selected - The following baud rates can be selected.
9600, 38400, 115200
(Irrespective of the selected baud rate communication at 9600 bps is allowed if
using the IrDA protocol.)
If "COM1" is selected - The following baud rates can be selected for RS-232C
communication.
9600, 19200, 38400, 57600, 115200
Combinations other than those described above are not permitted and will cause
a parameter error.
Mode
"H" - H/PC-to-H/PC command specification mode (Connection-wait time-out
is 1 minute.)
This option is used by one side which specifies the operation command when
performing communication between two H/PCs.
(The FLCE on the communication partner H/PC should operate in the idle start
mode.)
"I" - Normal mode (Connection-wait time-out is infinite.)
Only "H" or "I" can be specified.