Casio Cassiopeia PA-2400 - Manual (Page 22)

22
3.6.3 /D (delete) Command Option
These options (O: Forced deletion, R: Recursive call) of the delete command may not have a
corresponding operation provided on the communication partner side.
If this is the case, use this command without an option.
Table 3.6
Communication partner O option R option
Windows 95/Windows NT O O
DOS X X
Windows CE O O
O: Corresponds (specification permitted)
X: Does not correspond (specification prohibited)
3.7 Setting Up Registry
By writing a value in the registry it is possible to modify the default value of the communication
environment, etc. However, use the command line argument (/Y) to specify the communication line
or baud rate during normal use. Use this registry setup only if the default values require
modification. In other cases, where the drive letter definition requires modification, create the key
(item) of a drive letter and describe on the key the pathname of a device which will be defined
according to the specification.
If the registry has been set up, it will be remain valid until it is modified or the system is cold-started.
For a key (item) that is not set in the registry or a key (item) that has an incorrect setup the original
default value will be used.
3.7.1 Setup Items
Default if the RS-232C baud rate registry has no setup: 19200 bps
Default if the IrDA baud rate registry has no setup : 115.2 Kbps
Default if the communication line specification (232C= COM1 or IrDA) registry has no setup:
IrDA
Default if the drive letter definition registry has no setup value:
C
(Object Store of internal RAM)
D
Storage Card (storage card)