Casio Cassiopeia PA-2400 User Manual
Page 27
27
Table 3.7 List of Termination Codes
Error code
Categ
ory
code
Detail
code
Meaning Possible cause Remedy
00h 00h Normally terminated Normal. -
DCh
to
F5h
00h Normally terminated Formatting of drive a:
between 'A' and 'Z' is
specified from the partner
station. (For drive letter
definitions, refer to
Section 2.2.)
F6h 00h Normally terminated Power-off is specified from
the partner station.
Turn off the power.
F7h 00h Normally terminated. Resetting the power is
specified from the partner
station.
F8h 00h Terminated due to
interruption.
Communication is
terminated because the
break key is pressed on the
local station or partner
station.
Resume communication
as required.
01h 00h Protocol error. Data anomaly (data error
occurred on the
communication line).
Check the
communication line
connection.
02h 80h File not found. Non-existent file is specified. Check the specified file
or directory.
02h 81h Current directory delete
error.
An attempt has been made
to delete the current
directory.
Check the objective
directory of deletion.
02h 82h File write error Write to the file is not
possible.
Check if the file is
ready to be written to
02h 83h File read error. Read from the file is not
possible.
Check if the file is
ready to be read from.
02h 84h Read only access error An attempt has been made
to overwrite or delete the
read-only file.
Specify another file
name or cancel the
read-only attribute.
0Fh 01h Argument parameter
error
Incorrect argument
description.
Check the argument
parameter.
0Fh 02h Argument too long Argument portion of the
command line is too long.
Reduce the length of
the argument including
FLCE to 255 characters
or less.
0Fh 80h Reception data analysis
anomaly
Data analysis is impossible
due to a loss of reception
data.
Check the cable
connection and
mounting condition of
the H/PC on I/O Box
0Fh FFh System error Insufficient system resource. Increase the system
resource, then reboot
the system.
A0h 10h Communication port
open error
One of the other programs
is using COM1 or IrDA,
or FLCE is already initiated.
Terminate the program
that is using COM1 or
IrDA.