CANOGA PERKINS L357 Gigabit Ethernet Service Unit - Manual (Page 37)

EdgeAccess Universal Chassis System
L357 Gigabit Ethernet Service Unit 4-17
2. At the System Information screen, type the number for an item and press , then follow the
prompts to type in your information.
3. To return to the System Configuration menu, press .
System Information - Local Unit
1. System Name :
2. Contact :
3. Location :
4. Customer :
5. Information :
:
6. Circuits :
:
7. Service Code :
8. Date-in-Service :
9. Date-Out-of-Service :
10. Equipment Type :
11. Equipment Code :
12. Vendor :
13. CLEI :
14. Mfg Date :
15. Unit :
Figure 27. System Information Screen
4.6 Diagnostics Menu
Use the Diagnostics menu for troubleshooting the L357; you can view current loopback conditions
and set up loopback. See Figure 28.
DIAGNOSTICS
1) Loopback Setup
2) Remote Latency/Jitter Test
3) Remote Connectivity Loss Detection
Select [1 3]:
Figure 28. Diagnostics Screen
Use the Loopback Setup screen to view current loopback conditions and set up loopback conditions
for troubleshooting the L357. See Figure 29 and Table 9. For details about using loopback, see
Chapter 3. To run a loopback test, follow these steps:
1. From the Main Menu, type 2 , "Diagnostics," and press . The Diagnostics menu appears.
2. From the Diagnostics menu, type 1 , "Loopback Setup," and press . The Loopback Setup
screen appears.
3. Type the number for the loopback option you want to set, press to highlight the Remote
column if needed, press to cycle through the options, and press .