BendixKing KLN 35A - Pilots Guide System KLN 35A - Manual (Page 44)

KLN 35A Pilot’s Guide Basic GPS Operation
3-9 Effective Date 5/95 006-08791-0000 Rev 0
Basic GPS Operation
Chapter 3
The third line of the left side has three purposes: (1) If the KLN 35A
is ready for you to approve something, such as a selected waypoint,
the “Ent” prompt will flash (figure 3-27), indicating you should press
the
F
button to continue. (2) If the
KLN 35A has a new message for you
which must be viewed on a message
page, a large “M” will flash in the
same area (figure 3-28) telling you to
press the
C
button and view the
new message. (3) Immediately to the
right of the “message/enter” display
area, the navigation mode (see
sec-
tion 4.5 for details) is displayed. If the
KLN 35A is in the En route-Leg mode
(the normal mode of operation), “Leg”
will be displayed here.
The lower left corner of the display, where the page type and number
are usually displayed, can also display short operational messages to
the user called “scratchpad messages”. These messages are
displayed for approximately five
seconds, then this area returns to the
page type and number. Figure 3-29
shows an example of a scratchpad
message indicating a duplicate
identifier. A complete listing of
scratchpad messages is available in
Appendix C of this Pilot’s Guide.
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
åå.ånm H 276
ееееее HOTEL
Dup N 55°49.90'
Ident W 55°45.70'
Figure 3-29
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
åå.ånm ZBV 116.70
ееееее BIMINI
#>Leg N 25°42.10'
VOR 1 W 79°17.10'
Figure 3-27
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
åå.ånm ZBV ∂∆ KSEA
ееееее > ««««∑∏∫««««
{ >Leg 62.1nm 112kt
NAV 1 >262°To 0:33
Figure 3-28